Corrosion resistant vacuum pumpThe structure is well structured, corrosive and strong seals are robust, work is stable, noise is low and life is long. The following are operation processes for the use and maintenance of corrosion resistant vacuum pumps:
1. Check for any breakage in the combination of corrosive vacuum pumps and pipes. Test the flexibility of the pump with a hand-turned pump and then try to see the switch。
2. Add a bearing lubricant oil to the hanger and observe the oil levels between the two strokes of the oil mark。
3. Wrestle the pumping body's steering conch and pour water。
4. Seal valves and export pressure tables and import vacuum tables to close out of the pipes。
5. Turn on the power plant and, when the pump is operational, work on an export pressure sheet and an imported vacuum table, depending on the pressure shown, gradually open the valve and check the load of the power plant。
Maximum control of the flow and range of the pumps is indicated on the scale of the pumps to ensure that the pumps operate on a permanent basis near the point of efficiency in order to achieve greater energy efficiency。
7. During the operation of the pumps, the bearing shall not exceed 35 degrees ambient temperature and 80 degrees temperature。
8. In the event that an abnormal sound of a corrosion resistant vacuum pump is detected, the cause of the parking shall be immediately checked。
9. When a corrosive vacuum pump is to be stopped, the valves, pressure meters will be shut down and the power will cease。
10, corrosive-resistant vacuum pumps are replaced with lubricants for 100 hours during the first month of operation. Every 500 hours from now, change the oil。
Regular adjustment of filling pressure caps to ensure regular leakage in filling rooms。
12. When a corrosive vacuum pump is used during the winter season, when it is stopped, the water shall be purified by a conch in the lower body of the pump, which shall prevent the freezing of the water。
The corrosion-resistant vacuum pump is permanently disabled and shall be removed from all pumps and dry of the water, which shall be coated with grease and properly preserved at the turning and assembly points。
The use and maintenance of corrosion-resistant vacuum pumps are described in the process above and are first checked for loose damage to the corrosion-resistant vacuum pumps and repaired in a timely manner。
From http://www. Hnbf-pv. Com