Product name: silicon reprinting hand sense oil
Type: ats-1015
Rules: 1 kg, 5 kg, 10 kg, 20 kg
Usage method: spray
Dilution rate: white oil six times diluted
Solidification condition: 180-220°c bake 5-15min
Light: dumb light
Hands type: smooth
Product characteristics: extreme investment in silica reprinted products, smooth hands, good dustproofing, friction resistance, shaving resistance, alcohol resistance
Applicable to object: silicon cell phone suites, silicon tape bands, silicon bluetooth earpieces, silicon glue products, such as silica reprinting, thermal reprinting, internal printing, printing, etc
The method is used to clean the surface of the material to make it impurity-free, oil-free, etc.; the white oil is diluted with white oil before the use of the ink: one ink and six in white oils; the white oil is added three times to the dilution, on a first-to-first-to-low basis; the 3% catalyst ats-5002-mixing is added (the ink + white oil + platinum catalyst = 100+ 600 + 3), filtering sprayed with 300-400 leachs; and sulfide in dustless environments 5-10 minutes。
Construction conditions
Parameters
Spray viscosity (25°c)
8-10s
Spray distance (cm), caliber (mm), pressure (mpa)
20-25, 0. 8/1. 0, 0. 2-0. 3
Forced drying (180-220°c), min
5-15min
Standard film thickness, μm
20±2
Sealed in a cool, dry ventilation area (storage temperature 5 ~ 37°c, humidity 55 ~ 85%) with water, leak, sun, high temperature and distance from fire sources。
(a) a six-month warranty period
Attention
Apply
1. The product shall be fully modulated when opened and the catalyst ats-5002 shall be added after the ink has been diluted and evenly mixed。
2. Spraying must remain environmentally sound, and it is recommended that the operation be treated with no dust, with temperature at 20-30°c and humidity at 55-75%; too low temperatures lead to fluidity, reduction in adhesiveness, wetness over easy to cause membrane constrictions, and moisture is more likely to cause electrostatic dust contamination and safety hazards。
3. The product to be sprayed is best used after 100 °c/1 hours of double-sulphuration, so that the product can be fully fertilized, otherwise local sulfurization of the paint membrane may occur。
4. Sulphurization requires a stairwell and an incremental temperature. If baking occurs immediately after spraying and the temperature is too high, the surface is not even. The prepared ink should be exhausted within eight hours and the sealed refrigeration (0-10 °c) can be prolonged。
Clear
1. The product shall be used in conditions of good ventilation, with the necessary safety precautions to avoid significant human inhalation during the construction process and prohibit its consumption
2. Be careful with the use of the product and be careful with the entry before and when used. In addition, security regulations established by the relevant state or local government should be followed。
(detailed safety guidance referred to corresponding msds)
Statement: the information provided in this product description is based solely on the knowledge we have gained in laboratory and practice, and we seek to be accurate and believe in a high reference value. But since the use of the product is usually beyond our control, we give assurance only about the quality of the product itself. We reserve the right to modify this note without notice。
