(re-engineered parameters) reasons for failure are: 1 protection of component movements during start-up, which cannot be inhaled by the contact point, resulting in a repetition of the soft starter. (checking widgets and circuits)9 there was a heat failure light at startup and the soft starter stopped working: (b) a high rate of start-up, resulting in excessive temperatures and excessive heat protection actions for soft starters. 6av2181-5af20-0ax0 second generation mobile panel connector cable
(the load should be minimized at start-up)7 and during start-up, electrical currents are unstable and excessive. Reasons for this may be: one current chart indicator is inaccurate or not compatible with the sensor. (replace new current meters) 2 power grid voltage is unstable and volatile, causing a soft starter error. (contact with the manufacturer to replace the control panel) 3 the soft starter parameters are not set rationally. 6av2181-5af20-0ax0 second generation mobile panel connector cable
(check whether the electric power and the grid voltage are abnormal. Contact with the manufacturer to replace the controlled silicon) 3 filters piercing short circuits. (replace filter plates only) 6. The flexible starter displays a start time overtime when the load is activated. The soft starter is out of work and the electrician is free to park. The failure was due to: (re-engineered parameters, initial voltage increased appropriately, and time increased appropriately)。
Two soft starter control panels fail. (contact with the manufacturer to replace the control panel) 5, the soft starter is malfunctioning, the soft starter is not working and the electric power is not responding. The cause of the failure may be: (checking electric power and circuits)。
(it is recommended that users do not simultaneously start high power generators) 4 is fully loaded at startup. (at the start-up, minimize the load)4. When a user uses a soft starter, the screen is shown without a display or there is a disorder, and the soft starter is not working. The failure may be due to the convulsion of the internal line of the soft starter as a result of vibrations caused by external elements during its use。
The initial voltage parameters for the 2-soft starter are set too high or are set too long. (appropriately reduced or reduced start time of initial voltage depending on load)3 the higher voltage of the electricity grid during the start-up caused the soft starter to give the wrong direction and the advance bypass。
(soft starters must start no more than six times an hour, especially with regard to heavy loads)2 during the start-up, the protection of the action of the element, which prevents the contact person from standing aside, and the soft starter works for long periods, triggers protective action. (checking circuits) 3 the excessive load start time causes overheat protection. (at start, reduce as much as possible the load) 4 the parameters of the soft starter are unreasonably fixed。