Ds-k7pc91-push (domestic formulation)
Ds-k7pc91-pull (domestic labelling) arm pull
Installation conditions
(b) port weight: 80 kg (limit 100 kg)
(b) the size of the fitting door: 1000 mm (threshold 1200 mm)
Open angle 100°, recommend 90° installation
Product weight: 6. 5 kg; wall bearing: >20 kg; walls that must be installed in cement, red bricks or that can stabilize fixtures
The equipment is installed on the wall above the door frame at a height less than 30 mm (the distance between the location of the installation and the door fan). When the door is higher than 30 mm, separate parts (high interfaces) are purchased
Push arm installation: equipment should be equipped with less than 180 mm of embedded depth on the wall and side door. Otherwise it cannot be installed
Arming: the installation of the equipment will be on the same floor as the side of the door, otherwise the installation will not be possible. This can be done by adding self-propelled highs (e. G., wood bars) between the front of the door and the arm when installed。
Product characteristics
(b) automatic opening of microwave sensor signals
(b) open doors to receive door-barrier equipment to alert output signals
The left door, the right door, the inner door and the outside door are applicable and open 90 degrees
It applies to wooden doors, iron doors, etc., and needs to be installed on the wall of the gate
Support for the operation of remote control doors, doors and doors (two self-contained remotes)
(b) the opening of the door buffers can be reconciled; the speed of closing can be adjusted
Power:
