Full automatic soft water equipment
1Soft water treatment equipment is broadly adaptable and meets the different conditions of the user(industrial boilers, heat exchange energy, air conditioning, food, electronics, etc.) and the need for different water treatments can vary in flow depending on the user's request, in different control modes, and at different levels of consumption. This is due to its almost two valves and a combination of anti-cleaning and regenerative control of over a dozen, as well as different water intakes from 3/4 inches to 3 inches。
Two... Soft water equipment is efficient and low, and failure rates are extremely low. Maximum automation of the operation of equipment. Each of the pressured parts of the equipment was subjected to a rigorous o-14bar recycle pressure test, and the parts were designed as succinctly as possible to reduce their failure。
Three... Water conservation, electricity conservation, ease of adjustment. Equipment can produce up to 98 per cent of the water, with low electricity consumption (10w) and with multiple regenerative controls, allow users to adjust to the need to set appropriate regenerative methods。
FourFull automatic soft water equipment operates reliably and has a long useful life. The design of valves is carried out in the state of optimal hydraulics, and the design of valves is based on large, small export and import calibres, with different materials, and all large calibre products are made of lead-free brass, which makes flenk soften water equipment
It has more stable water quality and a useful life of up to 20 years。
Technical indicators:
Original water hardness: 3-10 mg. N/L
Source hardness: 0. 03 mgN/l
Work pressure: 0. 2-0. 6 mpa。
Working temperature: 2-50°C
Tank pressure:0. 8 mpa
Power: 220v50hz
Electricity consumption:10w
Loss of total pressure of equipment (pipeline + controller + water dispenser): 0. 1 mpa installation requirements, ground-based requirement levels, and water vents in the vicinity of the installation site. Pipeways should be installed by side and pressure sheets should be installed on the way into the water pipeline. The entry pressure is less than 0. 2 mpa required for piping. The salt is higher than the liquid surface of the salt and may not be used as a regenerative with sulfur or calcium salt。