Qinghai seining, winter steam generator, pre-fabricated sorghum steam generator, red peak. Mountain
Qinghai seining, winter steam generator, pre-fabricated sorghum steam generator, red peak. Mountain
The fuel utility electro-heating bridge conserver basically describes the principles of the steam generator: the bridge steam generator is powered by a 36kw/48kw electric heating tube or diesel fuel tank. The temperature control mechanism ensures that the operational temperature or high, medium and low electrodes feedback controls the opening, closing, and heating time of the furnace; the pressure relays adjust the vapour pressure, which drops with the continuous output of the steam, and when the water pump is at a low (mechanical) and medium (electronic) level, the pump stops filling when it is at a high level; and, at the same time, the heating of the electric thermal tube within the oven continues, with the source generating the vapour, and the table of finger pressure on the panel or upper pointers is marked with the vapour pressure value, which can be shown automatically through the signal light. Bridge maintenance installation and operation process: 1. Installation of valves, vents, pressure controllers and pressure meters after opening the container and attachment of pressure control lines to the pressure controller by number. 2. Connect the piped pipe with the piped pipe, open the piped valve and provide water, with a tap control device inside the tank. 3. To connect the power supply and then close the power switch, add a water indicator light, the water pump starts work and supplies water to the oven; until the water level is set, the water indicator light is extinguished, the heating indicator light is activated, and the internal vapour pressure of about three to four minutes is rated, at which point the gas valve can be opened and steam used. Fuel conservationer bridge conserver use: bridge conserver is also called vapour generator (commonly known as boiler). It is a winter prefabricated bridge, a t-barrel, and a concrete maintenance evaporation facility. It ensures that new concrete is hardened at an appropriate level over a period of time, and x prevents the early drying of concrete and its subsequent strength and durability. The bridge conservator is a small boiler that automatically and continuously produces higher pressure and steam, powered by electricity and free of noise. X-mass heated tubes with low surface heat loads and heat to facilitate installation and repair。
