I want you to meet the top three parts of the gas stove
We have two on the stove, a flat-head ignition needle and a sharp-head hot-fibre sensor。
The firearm will be damaged for three to four years. It's usually the fire extinguisher's high-voltage convulsion is out of capacity, or the resistance is rusty
Red is high voltage capacity failure rate of 60%, and the bouquet is resistance failure rate of 40%
Common malfunctions and diagnostic methods
1. Firing failure
Description of phenomenon: no sparks or sparks can light gas stoves after pressing the ignition button。
Possible causes:
Less than 50% battery power
Firing pointer offset or damaged 15%
The ignition line is exposed to a 15% failure
Ten per cent of ignition failure
Solutions: check whether the ignition is clean, adjust the distance between the ignition and the burner (usually around 4 mm). If the problem remains unresolved, the ignition or battery is replaced。
Picture description:
Repositioning the pins or grinding overcarbon paper
Figure: correctly adjust the distance between the ignition and the burner to ensure normal ignition。
2. Incendiary failure
Description of the phenomenon: the flame colour is abnormal (yellow or orange) and the flame is unstable or insufficiently burned。
Possible causes:
40% nozzle jam
50% of wind doors are not regulated properly
Gas pressure less than 10%
Solutions: clean up impurities in nozzles (with fine needles), adjust wind doors to the right position, and ensure a normal mix of air and gas。
Picture description:
Use a plum drill or an embroidery needle
Figure: cleaning of nozzles with a thin needle to ensure unhindered gas flow。
3. Leakage
Description: smells gas or hears leaks。
Possible causes:
Sealring age or 50% damage
The gas pipeline is 50% loose
Solutions: painting of suspected areas with detergent water to see if bubbles are produced. If leaks are detected, the gas valves are immediately closed and seals or tight pipes are replaced。
Picture description:
Swinging foam with detergent and water can be used to detect leakages
Figure : painting of the gas pipeline interface with detergent water to check if bubbles appear to determine leakage points。
4. Fire suppression protection device failure
Description of the phenomenon: the flames suddenly extinguished or could not continue to burn a few seconds after the gas stove was opened。
Possible causes:
Simple: thermal electrocutors are damaged or 80% carbon is accumulated
Complex: 20 per cent firepoint failure
Electromagnetic valve failure
Solutions: check if the thermoelectric doll is in good contact and replace the thermoelectric doll or electromagnetic valve if necessary。
Picture description:
If you burn too long, you'll have carbon
Figure: properly install thermoelectric dolls to ensure that they are in full contact with the flame to trigger fire suppression protection。
