The program chip burned。
A 160 plasma. Let's see what 160 plasma is. Just turn on the power, it's normal, the panel doesn't show it, but why doesn't it show? Let's find out where the problem is。
Open the panel and see that the obvious program chip has been burned. Let's see, this program chip has all been burned, the whole chip is dead. Can we fix it? We've removed the control panel. It's clearly burned. Can you see it
The tablet was then removed, and it was clear that the chip had been burned, so that it could not be repaired. What happens next? It's about 300 bucks on a board of this size. If you have such a tablet, it's the same as mine, you don't have to think about it, you can't fix it。
If you need a tablet, you'll leave a control panel on this side, which will be replaced directly to see where the problem is. When replaced, direct electrocution is applied, and a look shows that it is not normal. Once again the power switch is turned on, it is now clear that the display is normal and that the regulation is ok。
It then went straight to the pump cut, and then to the gas, and then it went straight to the gun switch, and it went up to the maximum, and the button turned to see if there was a fire。
