Home coffee machine
**note:** machines need water to turn on
I. Installation of coffee machines for debugging
Watering methods for coffee machines:
Outload bucket water (recommended. Better taste)
Directly from the top of the water mouth to the inner bucket, the water level is not less than 3cm.
Puffing methods for coffee machines:
Grab the barrel handle, turn your head up and lift it up and pull it out。
After the powder is filled, the drum covers and the feedstock drums are installed in a right-to-left sequence。
When installed, the recycle axis of the feedstock drum will be fully matched with the inner engine axis, and the prominent part of the feedstock drum will be fully matched with the fixed hole of the base plate。
The breakdown of the coffee machine
Fl: water in the water tank in the coffee machine, water in the upper bucket, no water test on the front panel: turn off the power switch, tap on the top of the back of the coffee machine 3 and re-open it. Dismantling the back panel of the coffee machine (upboard) note: (the water temperature sensor must be replaced with all the water in the machine in case of failure 3: the coffee machine has too little water (about half its normal value) or no water. Test: remove the back panel and resize the hydro-magnetic valve out of the water rotor (too big in time). If it's too big, the water leaks out of the rotor. When debugged, like too hot, replace the power plug. (if the voltage is too low, this will also cause the current failure 4: the coffee machine drops water at the vent or the machine leaks。
Test 1: check for a connection tube inside the machine with any cracks. If not, replace hydro-magnetic valves if broken。
Broken 5: the coffee machine turned on no light and was not operational。
Test 1: open the control panel to check if the basic set key is on the right。
2. Check the back fuses of the coffee machine for melting and the internal power supply. If the condition cannot be ruled out, remove the lower heating cans from the coffee machine, clear the marks and break them, and replace them if necessary。
3. Check for water rust in the bottom heating interface of the heating tank, if removed
4. If the above conditions are excluded, the type d operating plate or the main control malfunction will have to be replaced: the coffee machine beverage interface will be empty only and will not be powdered。
Test 1: check if the drums are empty, check if the white bends on the drums are directed
2. If it is downward, the non-powder drums are removed, the back is less severe by hand, the drums are outside, they are blown off and the hand turns. When you're setting up the drums, keep an eye on the back hole
3. If the above conditions are excluded, no powder drums can be removed from the offline and there are no cracks. In the event of a turn or a crack, the gear damage to the back panel of the coffee machine (upboard). Check the gears to connect to the horse's main control panel and replace delivery failure 7: café drum raw material fracturing。
