While the camera was filming, the camera suddenly pops the hint of a "carving error" and believes that a lot of good users have been through this "one-stop" moment. Don't worry, it's not as serious as you think。
I. Exchange the most course
First, remove the memory card and check whether the metal contact point has oxidation or stains. It can be rinsed with clean, soft rubber, and then refilled. It is also confirmed that the lock switch at the top of the card is not located at “lock”. Such “false failures” account for a significant proportion。
Ii. Physicological state check-up of the carton
If errors are reported after a clean contact, make a careful observation of whether there is a pin, an alien, or when the card is inserted, it is clearly loose. The sd card slots are thinner in the energy sector (e. G., 5d series, 6d series) and are prone to deformation with inappropriate plugs。
Iii. Card change testing and formatting
Change a positive memory card test. If the new card is normal, indicate that the original card has been damaged. If all cards are wrong, you can try to perform low-level formatting in the camera and clear the logical error。
Iv. Final judgement: aerobic calculus failure
If none of the above steps is effective, it is likely that the body-carat circuits or line lines have been damaged. Common causes include heat extraction, fall or long-term use of back-line fractures. This will require repairs, usually in the range of several hundred dollars。
Daily use of small stickers:
:: the habit of pulling cards after closing off
:: carry a spare card to quickly screen the source of the problem
• don't panic at a critical time. Most “carat errors” are just a card problem
If your camera also shows an anomaly, please leave a message
