When the eps light is on, it cannot be repaired and should be inspected at the nearby repair plant or shop 4s immediately, with targeted maintenance. The eps is a body electron-assisted conversion system, which, once the eps malfunction light on the dashboard has been activated, indicates that the electronic-aided switch system has malfunctioned and that a diagnostic device will be used to read the failure code and conduct targeted maintenance. The main reasons for the eps lights were the following: solutions: in this case, the eps failure light will automatically be removed when the vehicle is driven around 30-50 km after having been activated in situ and killed several times in the direction wheel. If failure lights cannot be removed by the above method, then rematch the data with a diagnostic device. 2. Damage to the twister sensor and damage to the inner circle of the sensor will also cause the eps malfunction light to be activated. Solutions: direct replacement of the twister sensor will solve the problem, but care needs to be taken that if it is integrated into a twister sensor inside the engine, then the total of the engine will need to be replaced. 3. The inflow of water within the direction aircraft, or the corrosion of the beam plugs, leads to a malfunctioning light, and the vehicle's engine is located below the vehicle's chassis, which is bound to be covered with dust and dirt for prolonged use, leading to a malfunction. Solutions: repair of damaged directional machines or beams will solve the problem. 4. Abs sensors are damaged or dirty, which is a common cause of failure, mainly because the eps system collects abs data while working and indirectly leads to eps failure lights if the sensor is damaged. Solutions: dismantling abs sensors, cleaning up the dust on top and reloading them back in the car. If the eps faillight is still on, it means that the sensor is broken and needs to be replaced。
