How does the glass door spring workCommon malfunctionsReason
Reasons for frequent failure of the glass door spring andMaintenance methods
One, the spring door is open
It is believed that this is the most important phenomenon and that for these doors the most frequent occurrence is the lack of closure, so the maintenance of the spring door is a priority. The main reason for this is that the glass door clamps are broken, that the glass door clips are loose, that if they are loose, one to two leather pads, they can be tightened, and if the glass door clips are broken, you can switch them off。
Two, spring door. Sound
The sound of the switch is also a very painful problem for the maintenance of the spring door, mainly because the glass door is rusty, and it has been found that if the spring is damaged, it can no longer be replaced, simply by selecting the right product for direct replacement, depending on the size of the door。
Three, under the spring door
These doors in the market, especially the glass doors, often encounter downside problems, which lead to very poor openings, making maintenance of the ground spring doors the main task, which is due to the lack of tolerance between the glass doors and the springs when glass doors are installed. The only method of repair is to replace the spring and repurchase a spring that is more resilient than the glass door weight so that the glass does not fall。
Four, the spring is off limits
(1) the spring fixed screws are unlocked, the body shakes and locks all fixed screws
(2) the spring cam will shake and switch
(3) the centre's shaking arm is wide and the centre's shaking arm is different
The glass door springInstallation technologyPoints
1 the limit slots for fixed glass on the beam of the door frame shall be narrow and coherent and vertically straight. The general limit slot is more than 2-4 mm thick and 10-20 mm deep, so that it is successfully inserted when glass panels are installed, seals are injected on both sides of the glass and fixed glass is secured。
2. When a wooden plate is nailed to a fixed glass plate at a distance of 4 mm from the glass so that the coating panel can wrap the inside side of the plate, so that it can be injected into the seal and so as to ensure that it is large and solid. 3. There are no door frames for the active door, the opening of the door is effected by the positioning of the spring and the door frame, which is linked to the top and bottom of the door. Therefore, it is important that the springs be tied to the locational sales and doorpans and that the surface beams are on the same line as the locational sales centre line so that the glass doors are open。
4. When the glass door is inverted, the angles and holes in the processing plant shall be sharpened. When selecting springs and their associated parts, particular attention should be paid to their quality and corrosivity, and to the quality of the springsLife expectancyThis would be longer, which would reduce the number of inspections and repairs. At the same time, attention should be paid to the compatibility and closeness of the spring with the holes hit by the ground, and the selection of springs capable of bearing the weight of doors is also essential。
