A guide for wind blowers without heat
What's wrong? Don't worry, i'll teach you how to fix it at home. Save a lot of maintenance money and get new skills
One plate failure check
The main issue is the wind blower's no-hot “heater zone”! Dyson's wind blower red light is the main plate calling the police. It's probably because the filter is too dirty to burn the main plate, or because of the lack of response from the plug. At this point, we're going to have to take off the wind dryer and look at the main plate。
The method of repair is to cut the electricity first, then carefully remove the wind blower's shell and find the main plate. The voltage is measured on a universal scale to see if there are any signs of burning on the main plate. If so, we'll have to change the main panel. But don't worry, there's a lot of lessons and accessories on the internet
2 hot-wire change course
Hot silk is the "heart" of the blower. Without it, there's no hot wind. If dyson's wind-dryer doesn't have a hot wind, it's probably just a fever. This is when we have to get a new hot wire and start changing
• replacement steps: power cuts followed by wind blowers. Find a hot spot and take it down. Watch out. Hot silk is fragile. Be careful not to break it. Put the new hot wire on it and fix it. Let's get the wind dryer back in there
3-ray motor inspection
The motor motor is the engine of the wind blower, and if it goes wrong, the wind blower goes on strike. Dyson's wind-blowing light is the electric motor calling for help! It could have been blocked by something, or broken by a circuit。
Check process: power cut first, wind dryer removed. Find the motor motor and see if it turns. If you don't turn, you have to clean up the alien in the electric power or check if the circuit is broken. If it's bypassed, we'll need a new motor. But don't worry, it's a little surgery. There's a lot of lessons to learn online
4x4 power lines overhaul
The power line is the “lifeline” of the wind blower, and if it goes wrong, the blower will be “power out”. If you find the wind blower squeezing the power line, it's bad contact
Physicology: first power cuts and then the wind blower casings are removed. Find the power lines and check its connection. If the power line is fractured or the connection is loose, the new power line will have to be repaired or replaced. Remember, when repairing power lines, wrap it in insulation tape. Don't lose power
All right, that's enough for today's wind dryer. I hope these little tricks help you! If you have any other questions or more maintenance knowledge, please leave a message in the comment area! Let's talk and learn and get the blow-blower back to life
