The electric water heater shows how e5 should be handled. What is the cause of the failure of the water heater e5? The failure phenomenon: when the water heater turns on, it does not work, it keeps warning of the e5 failure code, or it scintillates the e5 failure, and the machine itself has problems and cannot be used properly。
Important note: the failure of e5 does not cost a penny to solve, and it is not the other promises! Please read the following solutions to solve them
The heater shows the e5 check method:
1. To check whether the switch valves on the gas pipeline are fully open;
2. Check if gas is exhausted。
3. To examine whether there is electricity in gas-table residuals or gas-table batteries,
4. Check if the gas has been exhausted or if the pressure reduction valve is damaged。
Check for air in pipes. At a time of approximately 10 seconds, repeated ignition discharges the air from the pipe。
Water heaters show e5 solutions:
1. Checking for normal discharges
After long periods of use, water heaters are vulnerable to external influences and can easily relax or fall, resulting in flue intake and vents affecting the normal opening of wind pressure switches。
2. Check for differences in the pipe objects
Check if there's any alien in the pipe. If there is an alien, then it's detached。
3. Check if the water heater's wind machine is abnormal or not working
Check if the water heater's wind machine is abnormal or slow. If this happens, we need to clean or replace the water heaters。
4. Reset or restart water heaters
Reset or restart the water heater to see if it will resume work。
5. Power issues
Check if the power supply plug points are on, excluding the power supply component。
Six. Water trails cause hot water pipes to block
As a result, the back pressure of the water flow is greater to a certain extent, the water heater hydrogas connection will be considered to have been shut down and the gas shut down. Need to wash the water。
7. Hardware failure
If there is a breakdown of hardware following the above clearance, much of the damage is caused. Contact persons are asked to check the door. Tel.: 4006816768 (line number available)
The water heater always shows e5 overhaul points:
(1) primary electromagnetic valves are closed,
(2) the ignition device does not light,
(3) fault of gas-fired electromagnetic valves,
(4) the sensors are damaged,
(5) poor terrestrial contact with electrical controllers,
(6) fault problems such as temperature relays。
