The daffodilsAnd, in the name of the limbo fairy, the white stubbles and the green leaves are made out of each other, and the twigs of the small flowers, and the fragrance of the fragrances and the fragrance of the fragrances, which you all love。
In sufficient sunlight, flowers can bloom after 30-45 days, and can be grown by man-made adjustments to the seasons of the new year of the agricultural year, with the appearance of elegant flowers that can be shown to friends and relatives. Through your smart hands, daffodils, blades, buds, and all kinds of shapes
Select the stem
Part1
First of all, the right water plumes are selected according to the desired shape. In general, a water fairy with crab claws chooses a more flat, symmetriced root。
Remove the skin
Part 2
First of all, strip off the earth and the outside of the plume. The remaining roots and decaying impurities at the bottom of the plate need to be removed from the water so that clean scales or roots are not infected by pathogens。
Open position
Part3
A plume of a plume normally bends up to the side of the ball and requires a knife to the surface of the bud. On the left hand, the plume is squeezed with a knife in the right hand, arc line is drawn along a distance of about 2 cm from the root plate, and the blades of the surface are removed along the line to the end of the ball until all the buds appear。
I'm going to strip it
Part 4
Once the locomotive covers are in place, it will be necessary to remove all the scales caught between the buds so that there will be a gap between the buds so that they can be carved at a later stage. When engraving, a u-shaped knife can be used to reach the buds, so as to be careful not to hurt them。
Duplicate leaves
Part 5
Remove the buds from every bud. Both sides of the subballs are cut in the same way. In order to smooth the blade, it is possible to draw two straight lines on both sides of the budding blade with an oscillation of the blade from the end of the bud to the base。
Brush the ball
Part6
The engraved water fairies are immersed in the water basin so that the tubers fully absorb the moisture. After 24 hours, the impregnated plume is removed lightly and the slime on the runner is washed clean under the tap. If the plume is thicker and thicker after cleaning, it will be necessary to continue cleaning the day after the rewinding. If the slime is not washed clean, the sphere will be brown, affecting the effects of later reading。
Washing water for injuries
Part 7
After immersion, take paper towels over the horizontal cut of the sphere and wet the towels. And then put a pixie ball in a proper water basin of the right size, so that the proper amount of fresh water can wait for it to take root. Paper towels are less intensible than cotton and gauze, so they do not easily damage the roots when they are replaced by water. Of course, water-absorbed materials such as cotton and gauze can also be used to cover the engraved face, bearing in mind that covered paper towels and so on are brought to the water basin. Water should be at a level below 1/2 of the height of a plume。
After two to three days of engraving, the growth was good and the crab claws began to appear。
