I. Selecting the matrix
Before planting, the proper matrix is prepared, which prefers a wet environment, usually attached to trees, so that the matrix can select peat, leafy soil, pine bark, moss, etc., with good ventilation. The matrix should not be used directly, but must be sterilised first, so that the stone is not susceptible to disease during its growth. The flower basin needs to be appropriate in size, clean up, put stones or rubble on the bottom to help drain the gas, and finally put the matrix in。
Ii. Division
This was best in the spring months of march-april, when air moisture was higher and it would be better to live after planting. The choice of a strong and healthy quartz mast requires the cutting off of too long the roots, the roots, the roots, the roots, the two to three cm roots, each with two to three truncheons, and then planting them。
Iii. Commencement of planting
When planted, it can be done either by planting a tree or by planting a stone. If the tree is planted, choose the tree and cut some of the barks on the tree according to 30-40 cm, then put the seedlings on a mixture of mud and cow dung, and then shove them into the ground, then cover them with straw and tie them with bamboo. In case of pebble planting, a cave is to be dug out of the rock, and the pebbles are to be fixed with cow dung and slurry。
Iv. Cultivation conservation
It is a vagaries-resistant plant and light conditions do not need to be too good, so be careful not to be tanned after planting. The quartz prefers to be wet and the moisture must not be missing, specifically requiring water to be watered on the basis of the dry and wet state of the matrix, to avoid being too dry, to be free of water in the rain, and to be sprayed on the basis of water normally。
