Hello, welcome toPeanut Shell B2B Foreign Trade Network_Professional B2B E-commerce Platform_Free B2B Information Publishing Network!
18951535724

The yellow-breeding technique of chinese herbs teaches you how to grow and what needs to be taken in

   2026-08-03 NetworkingName820
Key Point:In september-november, when berries matured, they were fertilized in purple black and radiant. They do not fall off immediately after they are ripe, but are vulnerable to bird pecking and should be collected in a timely manner. Can be used to cut it with a fruit branch. The fresh fruit is immersed in water from 3-5d, and the seeds are washed out, dryed, the thin membranes attached to the surface of the seeds are removed and the sand is buried in

In september-november, when berries matured, they were fertilized in purple black and radiant. They do not fall off immediately after they are ripe, but are vulnerable to bird pecking and should be collected in a timely manner. Can be used to cut it with a fruit branch. The fresh fruit is immersed in water from 3-5d, and the seeds are washed out, dryed, the thin membranes attached to the surface of the seeds are removed and the sand is buried in the open. Seeds weighs 13 μg/chon and are male and female, and are common because of poor pollination, and can reach more than 30 per cent of empty seed, which is similar to the size of full grains, but of about 30 per cent less mass. They can be eliminated by water selection. Pre-selection seed sprouts can reach 60% ~ 80%。

Yellow plating technology

Early spring seedlings were planted between late february and mid-march. Seeds are first buried in mixed sands of 50 to 60 d to promote gestation, then 10 to 15 d can be sprung out of the soil, and the nursery has chosen the flat, fertile and wet sandy soil, which is torn to the ground, to be used for 15 cm, 1 m wide, sowing and sowing, 20 g/m ' , to sow the land thin, about 0. 8 to 1 cm, to cover the grass. When the seedlings are released, attention is paid to irrigation, pine soil and weeding. Upon the birth of a seedling, a pair of small leaves is shown, and they can be moved into a container bag to grow around 4 cm tall, 25-30 cm tall in a year, with a well-developed side-shut that can be planted out of a bed. It can also breed a year of bare seedlings, which are formed when they are 10-20 cm tall, remove weak seedlings, small seedlings, maintain a range of 10-15 cm, and pursue fat and thin humans and animals who urinate on water one or two times, or pig and cow dung with cakes and pickles one time. By the spring of the following year, a seedling of 60 ~ 70 cm tall and 0. 8 cm thick is grown up in the mountains。

Yellow plating technology

Forest plantations should be selected in broad north-east mountainous areas with fertile, humid and sun-oriented low or medium mountains at an altitude of 600 to 1,500 m. First, the mountains clean up the whole open cave with 50 cm x 50 cm x 35 cm, with a range of 2 mx2. 5 m ~ 2. 5 mx3m, or 1,800 ~ 2250/hm2. Before planting, each cave returns to the topsoil - at halftime, mixed fertilizer of 400 g or soil fertilizers of 10 kg, mixed with the ground, then refills the heart to the ground, tears out the sheet bags when planting in the early spring, leaves the soil undispersed, solid, tight and leaning. When the weather is dry, the water should be taken to the root, with an additional layer of pine soil. The seedlings shall also be placed in the straight e, with no bending of the roots, first filling the fine soil, and then pressing them down。

Yellow plating technology

In the three to four years since the nursery was managed, weeding, pine soil, den expansion, earth-breeding, branching and fattening have taken place every year. In april-may, ikei applied compound fertilizers of 0. 25 kg/punch or base weight of l0kg. To prevent human and animal abuse. After four to five years, the larvae is closed and can be managed once every two to three summers. Strong yellow hair and high growth can inhibit the growth of the main tubers, especially rare. Two years after planting, shearing begins, leaving only one fork branches, and the rest of them cut, year after year, to encourage the main stem to grow. An early levelling should be made, i. E., cutting from the ground 15 cm to the right before the early spring of the winter, waiting for many new sprouts to be sprouted in time, the retention of a healthy plant, the strengthening of culture, the application of fertilizers, a year of height of more than 1 m, the drying of trees, and their strength. It is desirable to dry it sooner rather than later。

Yellow plating technology

The main diseases in pest control are rust and coal pollution. The former are caused by the larvae in fungi and mainly by harmful leaves. In the early stages of the onset of the disease, there were yellow, green, near-round, microcrumbs, or summer spores piles. At a later stage of the disease, the scabies spread out of orange summer spores, and there was an increase in disease on the leaves, causing the leaves to die. - in mid-may, the weather was clear and rained, especially in the case of hot and wet diseases. For control purposes, 65 per cent of the dynamic zinc humid powder can be sprayed with 500 times more ~2-3 times, or 400 times more sodium enticing to enemy, or 0. 2 ~0. 3 degrees of thirate. The latter were killed by planting leaves or branches, covered with lead and black, or coal-grey molds, and dying in severe cases. They were able to treat pests first from may to june, spraying aphids, shellworms, 2-3 successive times with 40 per cent ointment milk, and 2-3 times with 0. 5:100 bordeaux。

Yellow plating technology

When the forest is too dense, the trees that mix them are cut off to increase ventilation, light and resistance. Insects include citrus butterflies, worms, u folds, oysters, etc. The citrus phoenix is the main pest in the yellow leaf, with larvae being used to feed young leaves, buds and seedlings. Prevention and protection of natural enemies and parasitic bees, with 300 times liquid cyanobacteria sprayed after three years of age. The worm is a pest dry, which can trim the twig, protect the natural enemy, or 90% trichlorfon 500-800 times the larvae is a mollusc to prevent the eradication of lime. The swarms are found in the trunks and the skins of the branches, causing the plant to grow poorly and even dry to death. 2-3 generations per year. Prevention of the spraying of 16-18-fold pine resin in april, june and september, or 4 per cent of the antiphosphate emulsion by 1,000-fold。

Yellow plating technology

More than 10-15 years after the harvest was processed, the skin can be skinned for medicinal use, and the older the tree, the better the quality. The harvest period is most appropriate in may-june. At this time, the temperature is high, the fluid flows fast, the water is abundant, the slime is abundant and skin is easily skinned. And when the tree is cut down, it is about 60 cm or so, and then it is stripped of its bark, and of its branches, and of its roots. They may also be replaced on a year-to-year basis without cutting trees and using partial skinning. Only part of the bark is removed vertically to heal and regenerate. The operation involves cutting a knife across the trunk, then cutting the bark down vertically and at depths that cut the pelvis without hurting the wood. After cutting, the whole skin grows more and more in 2-3 years. Every year thereafter, they rotated on the trunks. In the south, the peels of the trees are laid dry and flat, and then the coarse skin is scraped to the point where they appear yellow and do not hurt the insides. Finally, the processing cannons were made, the original medicine was immersed in the water for a little bit, the soil was washed, the sand, the dust was removed, it was removed from the bamboo basket, the shade was put back to 4-8d, and when softened, it was cut into a long strip of 2. 5-3 cm wide, and it was cut into a slice of 0. 2 ~ 0. 25 cm and dried. Salty is one of the more commonly used methods of making a tarp, which is smouldered with a proper amount of salt water in a yellow tablet, which is then damped back to the tide, and then made to the bottom of the pot with a pitcher and yellow, and is released. For every 100 kg yellow tart, 2 kg of salt is required for cooking。

Yellow plating technology

According to the information, yellow tart is made in 14 ways, which can reduce the bioalkali content and partially leachate, while also reducing the nitrite content of the toxic ingredient and reducing the inhibition of gastric fluids. In particular, the chills and the side effects can be mitigated。

Yellow plating technology

Experimental comparisons between yellow and different artillery products are initially considered to be a better process with c (170s), 8min and 240s) c, 5min. Processed cannons are placed in boxes, or other containers (sealed), in dry areas, wet and impotent。

Yellow plating technology

 
ReportFavorite 0Tip 0Comment 0
>Related Comments
No comments yet, be the first to comment
>SimilarEncyclopedia
Featured Images
RecommendedEncyclopedia