Longevity flowers reproduce in a variety of ways, including those, and let's look at them together
Longevity flower incubation
Long-lived flower incubation occurs mostly during the summer and fall periods, when light and temperature can guarantee better roots and survival. Plugging may be carried out with twigs and twigs, or with leaves。
In the case of a branch, it is necessary to select a healthier branch, cutting about 5-10 cm, and to keep five branches of a trim, and then cut the leaves of the two branches below, so that they can be kept in the matrix when they are dry。
In the case of leaf plugs, healthy and fat blades are selected, cut and then dry in a cool place, and can be laid shallowly in the sand or directly on top, keeping the soil wet。
The plume should preferably have a drainage and ventilated soil, with a choice of river sand and a slightly wet base。
It is a week or so after the plug is placed in the bright spot, so that it will gradually produce its roots and it will succeed。
Longevity flowers sow breeding
Seeding can be practiced in the spring or autumn after seed harvesting. Seeds are soaked with water before seeding。
The soil will be decontaminated and the seeds can be sowed directly on it, with a smooth spill that can be delayed to the ground. The seeding can be done with light pressure from a plank, and the whole seeding basin can then be placed in the water so that the soil is fully permeable, then the plastic membrane can be covered and placed in a warmer ventilated area, so that the soil is humid and normally fertilized for six months. When it sprouts, the plastic membrane is removed and exposed to sunlight, and it begins to grow to two or three leaves. When you grow strong, you can replant。
Attention is drawn to the need for artificial pollination when flowers bloom in their longevity in order to sow breeding。
Longevity flowers breed
Long-lived growth is not common and is a more complex method of reproduction
Cultivation is carried out using long-lived tubers, leaves, tubers, buds and flowers as implants for the grouping, and is then induced by the incorporation of 2 mg/l agonists and 0. 1 mg/l acetic acid in ms culture。
The root is then produced by a 1/2ms development of 1 mg/l 吲哚butyric acid induction, which is followed by 16 hours of light and a small plant after 4-6 weeks。
Longevity flowers breed in separate strains
(b) longevity flower breeding, preferably after the summer of the old plant
By late august and early september, the process of changing the soil will have to be carried out, with care to divide the large piles, using the knife into several tatters, and then plant another plant, which will then be able to take care of itself once or twice, prompting it to grow more and more。
