Lecturer at the teaching resource bank of the modern funeral technology and management professional group: ministry of finance
X-i. Seats and plugs are also referred to as thick ordinances or mesh. It is primarily used to test the size of the gap between the two sides. They consist of many thin pieces of steel of varying sizes, made of a single size by the size of the sheet, each of which has two parallel measuring scales and a thickness mark for combined use。
The use of x1. 1 septs is based on the size of the detected gap and selects the size of the sept; in order to ensure the accuracy of the measurements, the number of septs generally does not exceed three; if more than three, the correction values are usually measured. In general, each additional item plus a revised value of 0. 01 mm. When used in combination, thin slabs should be placed in the middle of the thick to protect the sheet. The stifling should be filled to a certain depth, with a certain resistance to death. The thickness of the plug can be measured in thousands of metres when the timing of the stifling is not visible or when the number of stifling is greater. When used, the plugs shall be cleaned and oil shall be worn for rustproof maintenance. (c) the gap (0. 04 mm) on the hard side of the bed of the test machine。
The thickness of single slabs of x1. 2 feet is generally 0. 02 mm, 0. 03 mm, 0. 04 mm, 0. 05 mm, 0. 06 mm, 0. 07 mm, 0. 08 mm, 0. 09 mm, 0. 10 mm, 0. 15 mm, 0. 20 mm, 0. 25 mm, 0. 30 mm, 0. 35 mm, 0. 40 mm, 0. 55 mm, 0. 50 mm, 0. 75 mm, 0. 75 mm, 1. 00 mm. 1. 3 the following should be noted in the use of stept: (1) the number of stepts selected on the basis of the gap between the sides, but the smaller the number of pieces, the better; (2) the measure should not be too hard to prevent the stifling and breaking of the stifling; and (3)
