Corn shredder。
Who can think of only drawing the contours of saws on board and cutting a hole along the marker line? Then a piece of wood of the same size was placed on it, and a marking point was drawn at the centre of the plank, opening a hole along the marking point with a hand drill. It was then drilled flatly into the interior along the hole, and a little bit of a circular dent that could accommodate the angular grinder parts。
Once this effect has been achieved, the planks are turned back and put strong glue on their tails so that a small plate can be attached to them as a pad. Then the horn grinder was firmly anchored on the plank with a stick. It then struck the end of the iron bar with a hammer into a straight angle, then turned the iron bar into a straight angle, making it a u-type opening structure。
Once another installation hole has been opened in the centre of the opening structure, the edges of the wedge can then be sharpened separately from the edges of the iron bar, so that the edges can be sharpened to make it better able to cut the shredded material. It is then fitted with accessories to the axle poles of the grinder in turn, and the plate is fixed。
A small metallic grid is also attached to a hole on the side of a plank as a filter, while a round transparent plastic paper is fixed on the outside with a self-attack screw, which is both dustproof and internal. Then you insert a bar into the sink on the side of the funnel, which is actually a manual feed switch. The funnel is then inserted into the upper hole, and on both sides of the plank, two wooden bars are fixed to support the pole, and two wooden bars to support the bottom of the support pole。
Here, a simple corn shredder is ready. Although the shredding is not particularly subtle, it is good enough to feed the chickens。
If it's 10 points, how much can you score for this craft
