The original plant parking radar price is around $600。
At the time of the production of the insurance poles at the carola plant, markings had been reserved for the installation of its reverse radar probes (a small circle can be seen on the back, with four symmetry on the back)。
When drilled, it can be drilled from the inside, simple, fast and accurate。
4. Generally installed at an altitude of 45 mdash55cm, the surface of the probe is vertically on the ground。
5. Installation of reverse radar: 1。
6. Check whether there are barriers to the internal structure of the post-bars, such as beams, shock buffer foams, etc。
7 and avoid such positions to the extent possible; 2. The distance between the eyebrows at the end of the post-colora bumper is the sum and the exact position of the four probes is measured and marked。
8. The four probes should be spread evenly across the same horizontal line, with symmetry on both sides of the licence plate and not too easy to install; 3. The marking openings followed by a dedicated drill, with a full-purpose drill, should be flattened from the left to the right, and should be loaded from the left to the right, with attention to the direction and angle of the probe; 4. Dismantling of the left urchin and tail lights in the carola trunk and installing the fixed reverse radar master control, which should be attached to the reverse light; 5. The soundness of the probes in the fixed security bar should be placed on the left side of the trunk of the trunk; 6. The fixed position of the radar display is generally located under the left a column; 7. The signal lines will be placed on the left side of the car door or the bottom of the mat to the left side of the carola reserve, which will be linked to the main control; 8。
