You know you use it every dayWater toiletStructureRationaleYeah? It is believed that many people, like the editor-in-chief, are wondering if one day our house is on strike with a flushing toilet, and it's exactly when it is needed, and it's too late for it. It would be necessary to know how to draw toilets, and when the toilet goes on strike, we can get in there and we can't help it。
The structure of the toilet
The toilet surface is divided into two main parts: toilet and water tank。
The toilet component consists of: hoses, control valves, drainage vents, drainage vents, flushholes and sewers. The toilet component is much simpler in structure than the water tank component, and the main work component of the pump is concentrated in the water tank component。
Water tanks include floats, regulators, buttons, water spills, upwater valves, spills, flushing plugs, leakproof rubber rings。
Pumping toilet work
When we run out of flush toilets, we press the waterproof button on the tank, and then the button pulls up the plug by leverage, and the water in the tank comes out, and when the water in the tank is released, the exit plug automatically falls, thereby blocking the vent, and the float will pull up the plug because the water surface is falling inside the tank, pushing the lever to pull it into the tank。
Water toiletInstallation method
The first is to maintain the level of the ground where the flush toilets are installed. The toilet would then be cleaned up and the sewer would be guaranteed to be about 5 mm above the ground. Check water tanks for leakage and fill them with water to test water pressure. Once the above work has been completed, the sit-ins can be fixed, which can be glued to the cement by pulling a bolt. Cleaning up the dirt near the restockers allows us to connect to the water tanks, flushing to check if the tanks are leaking, whether the sewage pipes are running, and if everything is all right, it means your flush toilet has been installed。
